User’s Manual Model : WMP-G11 (Wireless Lan Card)
1.0 Scope 1.1 Document This document is to specify the product requirements for 802.11 g/b Wireless Lan Card. This Card is based on Ralink chipset that complied with IEEE 802.11g and IEEE 802.11b standard from 2.4~2.5GHz, and it can be used to provide up to 54Mbps for IEEE 802.11g, or 11Mbps for IEEE 802.11b to connect your wireless LAN. With seamless roaming, fully interoperability and advanced security with WEP standard, 802.
2.1 Functional Block Diagram Mini CPI PC 802.11b/g 802.
2.2 General Requirements 2.2.1 IEEE 802.11g Section # Feature Detailed Description 2.2.1.1 Standard Ÿ IEEE 802.11g 2.2.1.2 Radio and Ÿ BPSK, QPSK, 16QAM, 64QAM, OFDM Ÿ 2400~2483.5 MHz ISM band Ÿ 11 channels for United States / Canada Modulation Type 2.2.1.3 Operating Frequency 2.2.1.4 Channel Numbers 13 channels for Europe Countries 13 channels for Japan 11 channels for Taiwan 2.2.1.5 Data Rate Ÿ 6, 9, 12, 18, 24, 36, 48, 54Mbps 2.2.1.
# Feature Detailed Description 11 channels for Taiwan 2.2.2.5 Data Rate Ÿ 11, 5.5, 2, and 1Mbps 2.2.2.6 Media Access Ÿ CSMA/CA with ACK Ÿ Average Power 16dBm at 11, 5.5, 2, and Protocol 2.2.2.7 Transmitter Output Power 2.2.2.8 1Mbps Receiver Ÿ Typical –83dBm for 11Mbps @ 8% PER Sensitivity Ÿ Typical –88dBm for 2Mbps @ 8% PER 2.2.3 General Section # Feature Detailed Description 2.2.3.1 Antenna Type Ÿ Integrated Printed-PCB antennas with dual diversity function 2.2.3.2 Ÿ 3.
2.3.1 Information # Feature Detailed Description 2.3.1.1 General Ÿ General Information shows the name of Wireless Adapter, Adapter MAC Address, Information Regulatory Domain, Firmware Version, and Utility Version. 2.3.1.2 Current Link Ÿ Current Link Information shows the Current Setting ESSID, Channel Number, Associated Information BSSID, Network Type (infrastructure or Ad-hoc network), WEP Status (enable or disable), Link Status (Connect or Dis-connect), 802.
# Feature Detailed Description wireless LAN settings 2.3.2.7 Roaming Ÿ Support Automatic or Manual Rescan to associate with access point. 2.3.3 Security # Feature Detailed Description 2.3.3.1 Encryption Ÿ RC4 encryption algorithm Ÿ Support 64-bit and 128-bit WEP encryption Ÿ Support open system and shared key authentication 2.3.3.2 WEP Ÿ Four WEP keys can be selected Management Ÿ STA with WEP off will never associate any AP with WEP enabled 2.3.3.3 802.
2.6 Requirements of Reliability, Maintainability and Quality # Feature Detailed Description 2.6.1 MTBF Ÿ Mean Time Between Failure > 30,000 hours 2.6.2 Maintainability Ÿ There is no scheduled preventive maintenance required 2.6.3 Quality Ÿ The product quality is followed-up by ALPHA factory quality control system 2.7 Environmental Requirements # Feature Detailed Description 2.7.1 Operating Ÿ Temperature operation when operating in ambient temperature of 0 ℃ to +55℃. Conditions 2.7.
Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
This device is intended only for OEM integrators under the following conditions: The antenna must be installed such that 20 cm is maintained between the antenna and users, and The transmitter module may not be co-located with any other transmitter or antenna, For all products market in US, OEM has to limit the operation channels in CH1 to CH11 for 2.4G band by supplied firmware programming tool. OEM shall not supply any tool or info to the end-user regarding to Regulatory Domain change.
Industry Canada Statement This device complies with RSS-210 of the Industry Canada Rules. Operation is subject to the following two conditions: 1) this device may not cause interference and 2) this device must accept any interference, including interference that may cause undesired operation of the device This device has been designed to operate with an antenna having a maximum gain of 4.74 dBi. Antenna having a higher gain is strictly prohibited per regulations of Industry Canada.
