User's Manual

LinkTek WL11N Wireless Broadband Router User Guide
iv
Before You Start
Please read and make sure you understand all the prerequisites for proper installation of your
new Wireless Broadband Router. Have all the necessary information and equipment on hand
before beginning the installation.
Installation Overview
NOTE: You must have an account setup with an ISP (Internet Service Provider)
in order to use this device for Internet access. Contact your preferred
broadband Internet service provider to set up an account.
The procedure to install the Wireless Broadband Router can be described in general terms in the
following steps:
1. Gather information and equipment needed to install the device. Before you begin the
actual installation make sure you have all the necessary information and equipment.
2. Install the hardware, connect the cables to the device and connect the power adapter.
3. Check the IP settings on your computer and change them if necessary so the computer
can access the web-based management software built into the Wireless Broadband
Router.
4. Use the web-based management software to configure the device to suit the
requirements of your Internet service.
Packing List
Open the shipping carton and carefully remove all items. Make sure that you have the items
listed here.
x One LinkTek WL11N Wireless Broadband Router
x
One CD-ROM containing the User’s Guide and Quick Installation Guide
x Ethernet cable
x
One power adapter
suitable for your electric
service
x
One Quick Installation
Guide
If any of the above items are missing, please contact your reseller.
CAUTION: The Wireless Broadband Router must be
used with the power adapter included with
the device. Using a power supply with a
different voltage rating will damage and
void the warranty for this product