User's Guide
Operating Frequency 2412-2462MHz ISM band
Modulation Schemes DQPSK, DBPSK, CCK, 16 QAM, 64 QAM
RF Channel Availability 11 channels for United States (2412 MHz to 2462 MHz)
13 channels for Europe (2412 MHz to 2472 MHz)
13 channels for Japan (2412 MHz to 2472 MHz), channel 14 only
available in DSSS mode (11 Mbps max)
11 channels for Taiwan (2412 MHz to 2462 MHz)
Data Rate Support for 54, 48, 36, 24, 18, 12, 9, and 6 Mbps OFDM, 11 and
5.5 Mbps CCK and legacy 2 and 1 Mbps data rates
Media Access Protocol CSMA/CA with ACK
Transmitter RF Output Power < 18.0 dBm EIRP (typical) including antenna gain
Operating Voltage 3.3 VDC via PC host miniPCI slot
Interface miniPCI formfactor
Device driver Support Microsoft® Windows® NT, 2000, ME, and XP
第十二條 經型式認證合格之低功率射頻電機，非經許可，公司、商號或使用者
均不得擅自變更頻率、加大功率或變更原設計之特性及功能。
第十四條 低功率射頻電機之使用不得影響飛航安全及干擾合法通信；經發現有
干擾現象時，應立即停用，並改善至無干擾時方得繼續使用。前項合
法通信，指依電信法規定作業之無線電通信。低功率射頻電機須忍受
合法通信或工業、科學及醫療用電波輻射性電機設備之干擾。
CAUTION:
This device is intended only for OEM integrators under the following conditions:
1. This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. In order to avoid
the possibility of exceeding the FCC radio frequency exposure limits, human proximity to the antenna (installed to end
product) shall not be less than 20 cm (8 inches) during normal operation.
2.•This Transmitter must not be co-located or operating in conjunction with any other antenna or transmitter
As long as the 2 conditions above are met, further transmitter testing will not be
required. However, the OEM integrator is still responsible for testing their end-product for any additional compliance
requirements required with this module installed (for example, digital device emission, PC peripheral requirements, etc.).
Additional Information that Must be Provided to OEM Integrators:
The end user should NOT be provided any instructions on how to remove or install the device.