User's Manual

Alpha Networks Proprietary and Confidential Information
8
guidelines for an uncontrolled environment can be satisfied. The end user has to also
be informed that any changes or modifications not expressly approved by the
manufacturer could void the user's authority to operate this equipment. If the size of
the end product is smaller than 8x10cm, then additional FCC part 15.19 statement is
required to be available in the users manual: This device complies with Part 15 of FCC
rules. Operation
is subject to the following two conditions: (1) this device may not cause harmful
interference and (2) this device must accept any interference received, including
interference that may cause undesired operation.
LABEL OF THE END PRODUCT:
The final end product must be labeled in a visible area with the following " Contains TX
FCC ID: RRK20105635A1 & IC: 4216A-WMPN075635 ". If the size of the end product
is larger than 8x10cm, then the following FCC part 15.19 statement has to also be
available on the label: This device complies with Part 15 of FCC rules. Operation is
subject to the following two conditions: (1) this device may not cause harmful
interference and (2) this device must accept any interference received, including
interference that may cause undesired operation.
NCC WARNING STATEMENT
Article 12 Without permission, any company, firm or user shall not alter the frequency,
increase the power, or change the characteristics and functions of the original design of the
certified lower power frequency electric machinery.
Article 14 The application of low power frequency electric machineries shall not affect the
navigation safety nor interfere a legal communication, if an interference is found, the service
will be suspended until improvement is made and the interference no longer exists.
The modular transmitter must be labeled with its own NCC ID number, and, if the NCC ID is
not visible when the module is installed inside another device, then the outside of the device
into which the module is installed must also display a label referring to the enclosed module.