tia l 802.16e Mini-card Module fid en Manual v1.00 om pa ny C on Product Model Name: WMX-MC01 Version: 0.1 2008/09/12 C This document contains confidential proprietary information and is the property of Alpha Networks Corporation. The contents of this document may not be disclosed to unauthorized persons without the written consent of Alpha Networks Corporation.
Contents 1.0 SCOPE....................................................................................................................................................................1 1.1 DOCUMENT ...........................................................................................................................................................1 1.2 PRODUCT FEATURES .........................................................................................................................................
1.0 Scope 1.1 Document l This document is to specify the product requirements for 802.16e Mini-Card Module. This Card is based on Sequans 1130/1140 chipset that complied with IEEE 802.16e standard at 2.5GHz band. tia 1.2 Product Features en Ÿ Ÿ 2.0 Requirements The following sections identify the detailed requirements of the 802.16e Mini-Card Module. fid 2.1 Functional Block Diagram 40MHz Oscillator on 12MHz 32.
2.2 General Requirements Feature Detailed Description 2.2.1.1 2.2.1.2 Standard Radio and Modulation Schemes Operating Frequency Channel Numbers Duplexing Modes Channel Bandwidth Transmitter Output Power at each Antenna Connector Receiver Sensitivity at each Antenna Connector Ÿ Ÿ IEEE 802.16e QPSK, 16QAM, 64QAM, OFDMA Ÿ 2.496GHz to 2.69GHz for licensed band ny C on 2.2.1.
2.2.2.3 Wireless transmission PHY Operating Voltage Current Consumption Form Factor 2.2.2.4 2.2.2.5 2.2.2.6 Ÿ Min-Card with USB2.0 I/F and MII I/F ( MII mac mode only ) Ÿ Ÿ U.F.L & SMA Plug Reverse compatible connector Support 2X2 MIMO Ÿ Ÿ 3.3 VDC +/- 5% < TBD Ÿ Non-standard size ( 66 X 30 mm ) 2.3 Compatibility Requirements This device passes the following compatibility requirements. Feature Detailed Description 2.3.1 2.3.
Federal Communication Commission Interference Statement - Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. en - tia l This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
valid and the FCC ID can not be used on the final product. In these circumstances, the OEM integrator will be responsible for re-evaluating the end product (including the transmitter) and obtaining a separate FCC authorization. End Product Labeling This transmitter module is authorized only for use in device where the antenna may be installed such that 30cm may be maintained between the antenna and users.
