User's Manual

42
2.5. Initialization
It is possible to initialize (reset the setting data and the log data to the default) the wireless unit directly without using
the initialization command.
(1) Hold down the INIT switch using something that has a needle-like tip such as a skewer.
* Start working after removing static electricity.
(2) Connect the AC adapter and the PoE injector, and then turn on the power.
(3) Wait until the ACT LED starts blinking red.
(4) When the ACT LED blinking red turns to blinking green, release the INIT switch.
Default of each interface after the initialization
Network interface
Default
Remarks
Wi-Fi interface (2.4G)
Off
Default after validating the interface
2.4 GHz, 1ch, HT40
Wi-Fi interface (5G)
Off
Default after validating the interface
5.2 GHz, 36ch, HT80
Ethernet (ETH)
-
Default fixed IP (192.168.0.3/24)
(Access will become available after approx. 150 seconds from the
start-up.)