User's Manual

3.5. Initialization

It is possible to initialize (reset the setting data and the log data to the default) the wireless unit directly without using

the initialization command.

1. Hold down the INIT switch using something that has a needle-like tip such as a skewer.

* Start working after removing static electricity.

2. Connect the AC adapter and the PoE injector, and then turn on the power.

3. Wait until the ACT LED starts blinking red.

4. When the ACT LED blinking red turns to blinking green, release the INIT switch.

Default of each interface after the initialization

Network interface

Default

Remarks

Wi-Fi interface (2.4G)

Off

Default after validating the interface

2412MHz, HT40

Wi-Fi interface (5G)

Off

Default after validating the interface

5180MHz, HT80

Ethernet1 (ETH1)

Default fixed IP (192.168.0.3/24)

(Access will become available after approx. 90 seconds from the

start-up.)

Ethernet2 (ETH2)

Default fixed IP (192.168.0.3/24)

(Access will become available after approx. 90 seconds from the

start-up.)