Quick Installation Guide

Before You Begin

DWL-G520I Internal Antenna Installation

• Make sure to turn off your computer and unplug the power cord.

A. High on the metal front of the chassis.

B. Use a clearance area which will not interfere with the plastic cover.

Identify an antenna installation location:

Remove the front plastic cover from the computer.

Carefully guide the antenna cable through the desired aperture

towards the PCI slots.

Verify proper clearance exists between the metal and front plastic

cover.

PAGE 1
DWL-G520I Internal Antenna Installation Before You Begin • Make sure to turn off your computer and unplug the power cord. Remove the front plastic cover from the computer. Identify an antenna installation location: A. High on the metal front of the chassis. B. Use a clearance area which will not interfere with the plastic cover. Carefully guide the antenna cable through the desired aperture towards the PCI slots. Verify proper clearance exists between the metal and front plastic cover.
PAGE 2
Pull the cable taut, expose the adhesive on the antenna, and affix the antenna less than 2cm from the cable hole on the clean metal surface. Attach the antenna cable to the DWL-G520I by gently pushing it into the on-board connector. Attach the antenna cable Install the DWL-G520I carefully and firmly seat it into an available PCI slot (may require removing an existing bracket on the computer back panel).
PAGE 3
Secure the DWL-G520I PCI bracket to the computer back panel. Ensure the cable is clear of sharp corners or edges, away from wide ribbon cables, and secure as needed. Replace the computer front plastic cover.