User’s Manual Model Number: WMP-G15 Model name: 802.
1.0 Scope 1.1 Document This document is to specify the product requirements for 802.11 g/b MiniPCI Card. This Card is based on Atheros chipset that complied with IEEE 802.11g and IEEE 802.11b standard from 2.4~2.5GHz, and it can be used to provide up to 54Mbps for IEEE 802.11g, or 11Mbps for IEEE 802.11b to connect your wireless LAN. With seamless roaming, fully interoperability and advanced security with WEP standard, 802.11 g/b MiniPCI Card offers absolute interoperability with different vendors’ 802.
2.2 General Requirements 2.2.1 IEEE 802.11b Section 2.2.2.1 Standard _ IEEE 802.11b 2.2.2.2 Radio and Modulation Schemes_ DQPSK, DBPSK, DSSS, and CCK 2.2.2.3 Operating Frequency_ 2400 ~ 2483.5MHz ISM band 2.2.2.4 Channel Numbers_ 11 channels for United States _13 channels for Europe Countries _14 channels for Japan 2.2.2.5 Data Rate _ 11, 5.5, 2, and 1Mbps 2.2.2.6 Media Access Protocol_ CSMA/CA with ACK 2.2.2.
_ 15dBm at 54Mbps 2.2.1.8 Receiver Sensitivity at Antenna Connector _ Typical Sensitivity at Which Frame (1000-byte PDUs)Error Rate = 10% at room Temp. 25degree C _ –87dBm at 6Mbps _ –86dBm at 9Mbps _ –85dBm at 12Mbps _ –82dBm at 18Mbps _ –79dBm at 24Mbps _ –75dBm at 36Mbps _ –71dBm at 48Mbps _ –69dBm at 54Mbps 2.2.3.1 Antenna Type _ I-Pex compatible connector 2.2.3.2 Operating Voltage _ 3.3VDC +/- 5% 2.2.3.3 CurrentConsumption _ 550 mA at transmit mode _ 200 mA at standby mode 2.2.3.
# Feature Detailed Description (enable or disable), Link Status (Connect or Disconnect), 802.11g Transmit Speed (6, 9, 12, 18, 24, 36, 48, 54Mbps), 802.11b Transmit Speed (1, 2, 5.5, 11Mbps), Signal Strength, and Link Quality. 2.3.1.3 Site survey To search the neighboring access points and display the information of all access points.. 2.3.2 Configuration # Feature Detailed Description 2.3.2.1 ESS ID y y 2.3.2.
# Feature Detailed Description authentication 2.3.3.2 WEP Management y y y 2.3.3.4 WPA&WPA2 y y Four WEP keys can be selected STA with WEP off will never associate any AP with WEP enabled WEP Key Format: Option for Hex format Support WPA/WPA2-PSK and WPA/WPA2-EAP Support Cipher Mode AES and TKIP 2.4 Mechanical Requirements # Feature Detailed Description 2.4.1 Length y 60mm 2.4.2 Width y 30mm 2.4.3 Height y 5mm 2.
2.7 Environmental Requirements # Feature Detailed Description 2.7.1 Operating Temperature Conditions y The product is capable of continuous reliable operation when operating in ambient temperature of 0 ℃ to +55℃. 2.7.2 Non-Operating y Neither subassemblies is damaged nor the operational performance is degraded when restored to the operating temperature after exposing to storage temperature in the range of –20 ℃ to +75 ℃.
Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
This device is intended only for OEM integrators under the following conditions: The antenna must be installed such that 20 cm is maintained between the antenna and users, and The transmitter module may not be co-located with any other transmitter or antenna, For all products market in US, OEM has to limit the operation channels in CH1 to CH11 for 2.4G band by supplied firmware programming tool. OEM shall not supply any tool or info to the end-user regarding to Regulatory Domain change.
