User’s Manual For 11N Wireless Lan Card Model Number : WMP-N12 Revision: 1.
Test Utility Installation: Hardware: RT3052 RGMII INIC test fixture, with gigabit Ethernet port computer Software: RT3x5x MII V1.0.1.0 1. Insert WMPN12 to RT3052 RGMII INIC test fixture, connect the test fixture to computer with Ethernet cable 2. Use RT3x5x MII V1.0.1.0, make sure the computer has installed the wincap.exe 3. Select GIGABIT INIC 4.
1.1 Document This document is to specify the product requirements for 802.11n Draft 2.0 Intelligent NIC Card. This iNIC Card is based on Ralink RT3052 single chipset that complied with complied with IEEE 802.11n Draft 2.0, IEEE 802.11 b/g standard from 2.4~2.5GHz. It can be used to provide up to 54Mbps for IEEE 802.11g , 11Mbps for IEEE 802.11b and 300Mbps for IEEE 802.11n to connect your wireless LAN. 1.
2.0 Requirements The following sections identify the detailed requirements of the 802.11n Draft 2.0 mPCI . 2.2 General Requirements 2.2.1 IEEE 802.11b Section # Feature Detailed Description 2.2.2.1 2.2.2.2 Standard Radio and Modulation Schemes Operating Frequency Channel Numbers y y IEEE 802.11b DQPSK, DBPSK, DSSS, and CCK y 2400 ~ 2483.
# Feature Detailed Description y y y y y y y –86 dBm at 9Mbps –84 dBm at 12Mbps –82 dBm at 18Mbps –79 dBm at 24Mbps –75 dBm at 36Mbps –71 dBm at 48Mbps –70 dBm at 54Mbps 2.2.3 IEEE 802.11n Section for 2.4G Band # Feature Detailed Description 2.2.4.1 2.2.4.2 Standard Radio and Modulation Type Operating Frequency Data Rate Media Access Protocol Transmitter Output Power y y IEEE 802.11n BPSK, QPSK, 16QAM, 64QAM with OFDM y y y 2400 ~ 2483.
2.3.1.2 2.31.3 2.3.1.4 2.3.1.5 Operating Voltage Current Consumption Form Factor and Interface LED y y y y 3.3VDC +/- 10% 450 mA at continuous transmit mode (2 Tx chains on ) 250 mA at continuous receive mode (2 Rx chains on ) PCI-E form factor y External LED function supported 2.4 Software Requirements The Configuration Software supports Linux2.6. This configuration software includes the following functions: y Information Information allows you to monitor network status.
# Feature Detailed Description y 2.4.3.2 WEP Management y y 2.4.3.3 2.4.3.4 802.1x WPA/WPA2 y y y y Support open system (OSA) and shared key authentication (SKA) Four WEP keys can be selected STA with WEP off will never associate any AP with WEP enabled WEP Key Format: Option for Hex format Support EAP-TLS, EAP-TTLS, and EAP-PEAP Support WPA/WPA2-PSK and WPA/WPA2-EAP Support Cipher Mode AES and TKIP 2.5 Mechanical Requirements # Feature Detailed Description 2.5.1 2.5.2 2.5.
Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
以下警語適用台灣地區 經型式認證合格之低功率射頻電機，非經許可，公司、商號或使用者均不得擅自變更頻率、加大功率或變更 原設計之特性及功能。 低功率射頻電機之使用不得影響飛航安全及干擾合法通信；經發現有干擾現象時，應立即停用，並改善至無 干擾時方得繼續使用。前項合法通信，指依電信法規定作業之無線電通信。低功率射頻電機須忍受合法通信 或工業、科學及醫療用電波輻射性電機設備之干擾。 本模組於取得認證後將依規定於模組本體標示審合格籤，並要求平台上標示「本產品內含射頻模組：ID 編 號」 Alpha Networks Proprietary and Confidential Information 9
