User's Manual

Adapter Installation

1. Turn on the computer and Insert the Alpha WUS-N10 Driver CD in the

CD-ROM drive

2. When the auto run screen appears, click Install Drivers.

The InstallShield Wizard window will appear.

3. By default setup will install to the default location: To install to a different

location click Browse and specify the location.

4. Select the Program Files folder location

5. Insert the adapter into an available USB port on your computer.

6. The Wireless Connection Wizard will now appear.

7. To connect to your network using the WPS push button configuration

method, click the virtual button as shown in the screenshot.

Federal Communication Commission Interference Statement

This equipment has been tested and found to comply with the limits for a Class

B digital device, pursuant to Part 15 of the FCC Rules. These limits are

designed to provide reasonable protection against harmful interference in a

residential installation. This equipment generates uses and can radiate radio

frequency energy and, if not installed and used in accordance with the

instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular

installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off and

on, the user is encouraged to try to correct the interference by one of the

following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from that to

which the receiver is connected.

- Consult the dealer or an experienced radio/TV technician for help.

This device complies with Part 15 of the FCC Rules. Operation is subject to the

following two conditions: (1) This device may not cause harmful interference,

and (2) this device must accept any interference received, including

interference that may cause undesired operation.

FCC Caution: Any changes or modifications not expressly approved by the

party responsible for compliance could void the user's authority to operate this

PAGE 1
Adapter Installation 1. Turn on the computer and Insert the Alpha WUS-N10 Driver CD in the CD-ROM drive 2. When the auto run screen appears, click Install Drivers. The InstallShield Wizard window will appear. By default setup will install to the default location: To install to a different 3. 4. 5. 6. 7. location click Browse and specify the location. Select the Program Files folder location Insert the adapter into an available USB port on your computer. The Wireless Connection Wizard will now appear.
PAGE 2
equipment. IMPORTANT NOTE: FCC Radiation Exposure Statement: This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. End users must follow the specific operating instructions for satisfying RF exposure compliance. IEEE 802.11b or 802.11g operation of this product in the U.S.A. is firmware-limited to channels 1 through 11.