ALPHA WUS-N10 USB wifi module User’s Manual Release 0.
Federal Communication Commission Interference Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
This device is intended only for OEM integrators under the following conditions: 1) The antenna must be installed such that 20 cm is maintained between the antenna and users, and 2) The transmitter module may not be co-located with any other transmitter or antenna. As long as 2 conditions above are met, further transmitter test will not be required.
Introduction The WUS-N10 which is based on the RT3070, is a 802.11 b/g/n wireless embedded Mini-PCI module for AP/ Router + AP. WUS-N10 will be a RF module of AP board. It has greater throughput at longer range. The WUS-N10 is a green product. Features y y y y y y y y y y y y y y y y y y Compatible with IEEE 802.11n draft 2.0 standard to provide up to 150Mbps data rate. Compatible with IEEE 802.11g standard to provide up to wireless 54Mbps data rate Compatible with IEEE 802.
Installation y y y y y y y Turn on the computer and Insert the Alpha WUS-N10 Driver CD in the CD-ROM drive When the auto run screen appears, click Install Drivers. The Install Shield Wizard window will appear. By default setup will install to the default location: To install to a different location click Browse and specify the location. Select the Program Files folder location Insert the adapter into an available USB port on your computer. The Wireless Connection Wizard will now appear.
