Instruction manual

2.9 Service Power Inserter (SPI)
To connect the coaxial cable
Before you remove the cover, unplug the SPI from the power supply.1.
Remove the two screws holding the cover to the SPI chassis.2.
3.
4.
Tighten the seizure screw to 35 inch-pounds.This will prevent arcing within the SPI due to 5.
an improperly seated cable or loose connection.
Fig. 2-16, SPI Cover Removal
2
3
1
Seizure Screw
Assembly



CAUTION!
39
017-805-B0-010 Rev. K