Manual

AIP900-0012-B0-001 Rev. A (01/2012)

2.4 Installing the Rectier Modules

Before installation, verify all upstream and downstream circuit breakers are in the OFF (open) position.

TheRectiershelvesarefactory-installedandpre-wired.Intheeventashelfrequires

removal or replacement, contact Alpha Industrial Power service at 1-800-996-6104.

NOTE:

Rectier Module Installation Procedure:

1. Loadtherstmoduleintheleftmostpositionontheshelf.Populatetheshelffrom

left to right. Do not force the module into place; all modules are keyed to ensure the

correct module (voltage/polarity) type is used.

2. Insertbyplacingtherectiermoduleontheshelfbottomandslidingthemoduleinto

therearconnector(insidetheshelf).Pressrmlyintoplacetofullyengagetherear

connector in the shelf receptacle.

3. Turn the front panel thumbscrew to secure the module in place.

4. Reverse the above steps to remove a module.

5. Repeatforeachsucceedingmoduleintheconguration.

Fig.2-2,RectierModule

2.0 Installation