User Manual

745-838-B2-001 Rev. A

3.0 Installation Instructions for Speciﬁ c Power Supplies, continued

3.3 Alpha AM/AP Series Power Supply, continued

3.3.2 Output Voltage Calibration

No calibration is necessary for the Alpha AM/AP power supply.

3.3.3. Provisioning the Transponder on the Network

The transponder must be recognized by the CMTS as a valid device and be able to

obtain an IP address and communicate with the SNMP management server.

Load the transponder’s MAC address into the CMTS.1.

Setup SNMP using the two propriety MIBs ﬁ les.2.

Compile the two MIBs onto a network manager or MIB browser software.3.

Set the MIBS points for the AM/AP as follows:4.

Oid: 1.3.6.1.4.1.2183.2.3.3.1.2 set to (4) (power supply

selection)

Oid: 1.3.6.1.4.1.2183.2.3.6.5 set to (3) (acNormal for

output voltage measurement)

Oid: 1.3.6.1.4.1.2183.2.3.6.6 set to (1)for 110V powered

supply or (2) for 220V (input voltage measurement)

See Section 4.0, Proprietary Management Information Bases (MIBs) for detailed

information.

Install and conﬁ gure the DOCSIS conﬁ guration ﬁ le. See Section 2.1.9 for a 5.

sample ﬁ le.