Instruction Manual

9
016-559-B0-001 Rev. A
2.0 Installation
2.1 Enclosure Installation
2.1.1 Strand Mounting
Tools Required:
• 1/2” Socket
• 0-100 in-lb torque wrench
Procedure:
1. Loosen the two strand clamps on the enclosure. Ensure that the side labeled "INPUT" is facing the
correct direction.
2. Place the strand wire under the clamp plates and torque the bolts to 75 in-lbs.
3. Ensure that the output voltage is confi gured properly. Refer to section 2.2 if the output voltage requires
changing.
4. Prepare the coaxial connector(s) as outlined in Section 2.3, "Cable Preparation". Install the
connector(s) and tighten to proper torque supplied by the manufacturer.
Strand Wire
Strand Clamps Strand Clamps
Side View
Top View