User Manual
NOTES: 1. The UPS will be internally conî‚¿gured for either 208V or 240V output.
Check the nameplate rating of the UPS to verify the correct voltage.
2. Omit this connection if 120V output is not required or available.
3. Terminal designations are shown for Standard VBPT Series. If BPT -S Series
transformer is used, refer to label on transformer for actual terminal designations.
Figure 6.7
System Bypass Schematic
208V IN - 120V/208V OUT
2
2
1
NOTE 3
Schematic Diagrams
Doc# 020-133-B0 Rev. 01 / 07
19