Operator`s manual

23 2 Installation
2.8 Transformer Output Load Sharing
2.8.1: Transformer Output
The units have a single phase output. They do NOT have three phase characteristics.
Figure 2.10 shows the voltages between L1, L2 and N for 120/208/240 units and between L and
N for 230 VAC units
2.8.2: Load Sharing
The total current drawn from each winding must not exceed that winding’s maximum output
current rating (Figure 2.11). For 60 Hz units, where possible, connect 120 VAC loads to L1.
Since loads are shared between windings, you can exceed a winding’s output without exceed-
ing the unit’s maximum current output. There are two ways to calculate the current drawn by the
loads; measuring or displaying the output current.
zH060003RFCzH060003RFC
zH060003RFC
zH060003RFCzH060003RFC zH050003RFCzH050003RFC
zH050003RFC
zH050003RFCzH050003RFC
1L1L
1L
1L1LspmA0.52spmA0.52
spmA0.52
spmA0.52spmA0.52LL
L
LLspmA0.31spmA0.31
spmA0.31
spmA0.31spmA0.31
2L2L
2L
2L2LspmA4.41spmA4.41
spmA4.41
spmA4.41spmA4.41----------------------
-----------
----------------------
Figure 2.11
Transformer Output Current Ratings
230 VAC
120 VAC
120 or 88 VAC
208 VAC
240 VAC
L1
N
NEUTRAL
FERRO
TRANSFORMER
240 or 208 VAC
32 VAC
120 VAC
88 VAC
120 VAC
60 Hz Units
L
50 Hz Units
FERRO
TRANSFORMER
Figure 2.10
Transformer Output