Owner manual

14
3 Operation
3.2 RCU Configuration Procedure
Position jumpers or 0 Ohm resistors according to the following chart.5
deriuqeRderiuqeR
deriuqeR
deriuqeRderiuqeR
segatloV
tnemecalPrepmuJtnemecalPrepmuJ
tnemecalPrepmuJ
tnemecalPrepmuJtnemecalPrepmuJ
*1tupnI
tnemecalPrepmuJtnemecalPrepmuJ
tnemecalPrepmuJ
tnemecalPrepmuJtnemecalPrepmuJ
*2tupnI
CAV021CAV021
CAV021
CAV021CAV021
3R,2R,1R9R,8R,7R
CAV802CAV802
CAV802
CAV802CAV802
6R,5R,4R21R,11R,01R
CAV042CAV042
CAV042
CAV042CAV042
6R,5R,4R21R,11R,01R
* NOTE: Input 1 and Input 2 must always
be configured for the same voltage
Figure 3.7
Input 1 and 2 Jumper Configuration
Verify the Input 1 and 2 voltages are configured identically.
Close the front panel.
Test it for proper operation (Section 3.1) and required voltages.
7
6
8