Alpha Continuity Battery Pack User Manual Document #: 0320004-J0 Effective 02/2011
Alpha Continuity Battery Pack NOTE: Photographs contained in this manual are for illustrative purposes only. These photographs may not match your installation. NOTE: Operator is cautioned to review the drawings and illustrations contained in this manual before proceeding. If there are questions regarding the safe operation of this powering system, contact Alpha Technologies or your nearest Alpha representative.
Contents 1. Important Safety Instructions .............................................................................................................. 1 2. Overview of the Front and Rear Panel ................................................................................................. 3 2.1. 3. Front and Rear Panel Descriptions ............................................................................................... 3 Installation and Operation.............................................
1. Important Safety Instructions Save These Instructions This section contains important instructions that must be followed during the installation and maintenance of the equipment and batteries. Read all of the instructions before operating the equipment, and save this manual for future reference. The following safety symbol is found throughout this manual: Carefully read all information and abide by the instructions.
This battery pack is intended to be connected to an UPS. There will be a DC voltage at the connector terminals. Do not try to repair the unit yourself, contact your local supplier or your warranty will be void. To eliminate any overheating of the battery pack, keep all ventilation openings free from obstruction and do not place any foreign objects on top of the battery pack. Keep the battery pack 20 cm (8 in) away from the wall.
2. Overview of the Front and Rear Panel 2.1. Front and Rear Panel Descriptions 1 Screw Cover To replace batteries, remove the front covers and the screws inside the covers. 2 EXT.BAT. +/- To the DC terminal of the second (or next) connected battery pack. 3 UPS BAT. +/- To the UPS DC terminal or the next battery pack. 4 DC Breaker 1. Battery Over-current Protection Breaker 2. To swap a battery, put the position of the breaker in “O” position.
3. Installation and Operation Note: The packing condition and the external outlook of the unit should be inspected carefully before installation. Retain the packing material for future use. 3.1. Unpacking 1. Take the battery pack out of the foam. 2. Remove the packing materials. WARNING: The battery pack module is approximately 32 to 36 kgs (70 to 80 lbs); be cautious when unpacking and lifting the unit to avoid injury.
3.2. Selecting an Installation Position The battery cable is provided with an 8 inch cable. Plan to install the battery pack within 3 to 4 inches from the UPS or another battery pack. It is necessary to select a proper environment to install the unit, in order to minimize the possibility of damage to the battery pack and extend the life of the batteries. Please follow the instructions below: 1.
3.2.1.
3.2.2.
3.2.3.
STEP 3 STEP 4 0320004‐J0 Rev A Page 9
3.2.4.
3.2.5. Storage Instruction For extended storage in a moderate climate (-5 to +30 °C / 23 to +86 °F), the batteries should be charged for 12 hours every 6 months by plugging in to a UPS. Repeat this every 3 months at higher temperatures (+30 to +45 °C / +86 to +113 °F). Do not store batteries under conditions that are outside of this range. 3.2.6.
3.3. Specification UPS 1000VA 2000 VA Battery Pack Model BBC-AIDCO-1000 BBC-AIDCO-2000 BBC-AIDCO-3000 Part Number 0320004-001 0320005-001 0320006-001 Nominal System Voltage 36VDC 72VDC +(Red) 3000 VA +(Red) G(Green) DC Sockets Diagram G(Green) -(Black) -(Black) DC Plug Diagram Dimensions W x D x H, mm Unit 440 x 650 x 88 Shipping 560 x 833 x 228 Weight, kg Unit 38 38 44.6 Shipping 46 46 52.6 3.4.
Alpha Technologies Ltd. 7700 Riverfront Gate Burnaby, BC V5J 5M4 Canada Tel: +1 604 436 5900 Fax: +1 604 436 1233 Toll Free: +1 800 667 8743 Alpha Technologies Inc. 3767 Alpha Way Bellingham, WA 98226 United States Tel: +1 360 647 2360 Fax: +1 360 671 4936 Alpha Industrial Power Inc.
