Manual

107
0700015-J0 Rev B
9.2.3 Direct Connection Properties
Right-click on the DIRECT CONNECTION icon to verify the properties of the new connection as follows:
General Tab
Select a device COMMUNICATIONS CABLE BETWEEN TWO COMPUTERS…
as shown above.
Options Tab
Uncheck PROMPT FOR NAME…
Security Tab
Check TYPICAL (RECOMMENDED SETTINGS) and select ALLOW UNSECURED PASSWORD.
Networking Tab
Select PPP type. Ensure component TCP/IP is checked and uncheck all others.
Sharing Tab
No changes are required.
9.2.3.1 Modem Configuration
Under the General tab of the Direct Connection properties click on the CONFIGURE button to open the
Modem Configuration window and set the COM port speed to match with the server’s baud rate; typically
57600 bps as below:
Figure 133 — Direct Connection Properties