Manual

0700015-J0 Rev B
84
6.7.3.4 Example One – Logging Three Phase Voltage Input (Rectifier System)
The following is an example of a Data Log configured to monitor the voltage input for a two phase rectifier
system.
1. From the web interface, select Signals > Configure Data Logging.
2. Under Data Log Files, select an unused log file to edit.
3. Enter a filename description under File Information.
4. Enter the number of Log Records you want to keep and select FIFO as the File Save Option.
5. Under Start Trigger and Stop Trigger, select Manual for each.
6. Under Log Frequency, select Enable Time Interval and enter 600 seconds (10 minutes).
7. Click the Log Signals button to select the rectifier signals for logging.
8. Select Rectifier Signals from the Signal List in the Configure Signals window.
9. Scroll down and check each phase box as shown.
10. Click the Apply tab (to accept changes and return to Configure Data Logging window).
11. Click the Save icon to save the changes and click Accept when prompted.
12. Start the log by clicking the Start button located next to the File Information heading (see Figure 95.
Once the data has collected for the desired interval, return to this window and click the Stop button.
13. Select Logs & Files > Retrieve Logs. Select the file name from the pull-down menu and then select
Data Log to view the log information in a new window. Copy and paste the data into a spreadsheet
application for analysis.
Figure 95 — Configure (Signals) Data Logging web interface window, example one
Figure 96 — Enable (Rectifier) Signals for Data Logging