Specifications

12 010-322-C0-003, Rev C
1.0 Installation, continued
1.3 Battery and Remote Temperature Sensor Probe Installation
The diagram below is for illustrative purposes only. Exact battery orientation may vary. Do
not connect the batteries to the Flexnet 300 unit at this time. The RTS must be taped to the
side of a center battery as shown below. Connect the other end to the RJ-11 temperature jack
on the front of the power supply.
4A 3A 2A
1A
Air Gap
To “Battery” connector
To “Temperature” connector
Red
Black
Red
Fig. 1-3, Battery Layout and RTS Placement