Owner's manual

Specifications for Argus Technologies’ FMPS

Argus Technologies Ltd. 010-592-B1 Rev A WC

Input

Voltage (nominal): 120Vac @ 2.5A; 240Vac @ 1.25A

Frequency: 50/60Hz

Current (maximum): 2.5A @120Vac (maximum DC output + charger + heater)

Inrush Current: 4.1A maximum (peak value)

Surge Protection: ANSI/IEEE Std. C62.41 to Category A, B, or C requirements,

using a “Ring Wave” or “Combination” waveform, at a level of 6kV

Output

Power: 150W continuous; 170W, 10 second maximum

Voltage (nominal): 55Vdc

Current: 3.1A typical (crowbar limited beyond 4A DC)

Short Circuit: 5A

Loading: Following GR-909 telephone lines in various states; e.g., ringing, off-hook, on-

hook, data, and video operation requirements

Ripple: < 3mV

RMS

Noise: < 100mV

p-p

In accordance with FCC requirements, we provide the following statement as specified in the FCC guidelines for

conformance to Part 15, Class B:

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential installation. This equipment generates,

uses, and can radiate radio frequency energy and, if not installed and used in accordance with

the instructions, may cause harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation. If this equipment does cause

harmful interference to radio or television reception, which can be determined by turning the

equipment off and on, the user is encouraged to try to correct the interference by one or more of

the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

• Consult the dealer or an experienced radio/TV technician for help.

Any changes or modifications to this equipment not expressly described in this manual could void the FCC

compliance.