User manual
12 
from the  second  group (parameter 2).  The next  press  of the  same 
button again selects the number from  
If  the button is pressed after  the  line  has  been  opened  (but  before  the 
call is answered), the unit will hang up for the period given by parameter 54, lift 
up the line and dial the other group number. 
The relay can be controlled by pressing the buttons in the combination 
that is set in the preprogrammed code (parameters 32-34). The time between 
presses must not be bigger than that set in parameter 53. The unit will lift up 
and close the corresponding relay or the period given by parameter 36 . Then it 
will hang up. 
3.2.1 SlimDoorPhone with Keyboard 
The keyboard has two functional buttons   
key  symbol  =  once  pressing  the  numerical 
combination  is  considered  as  the  combination  for 
control  of  the  switches.  The  second  button  X 
symbol = when pressing the guard immediately will 
hang up. 
The incoming person is dialing number as to 
be  done  on  phone    the  period  among  button 
presses  should  be  lower  than  the  value  given  by 
parameter in keyboard. After this period the guard will lift up and dial the given 
number. 
3.3  Telephone Caller 
A  Telephone  Caller  is  a  person  that  is  in  phone  connection  with 
SlimDoorPhone. 
3.3.1 Outgoing call 
An  outgoing  call  is  a  call  from  the  unit  (i.e.  when  a  visitor  presses  a 
button).  Once  the  visitor  has  pressed  a  button  a  telephone  will  ring.  On 
answering the telephone, you will  be able to  converse with  the visitor.  10 
seconds before the maximum call duration (parameter 52) the unit will emit a 
tone to warn that the call will end. The call may be extended by pressing the 
key  as  set  in  parameter  42.  A  code  may  be  dialled  to  close  the  relay 
(parameter 35), releasing the lock. Hanging up the telephone will end the call, 
as will the busy tone from the PBX. 
3.3.2 Incoming call 
An incoming call is a call to the unit. After dialling the PBX extension number to 
which the unit is connected, the unit will ring for the set number of rings 
(parameter 51), the unit will lift up and it is possible to speak. The possibilities 
are the same as with outgoing call (Chapter 3.3.1). It is also possible to switch 
between Day and Night service. 










