User manual

The unit stays inactive in programming mode for 34 seconds and will then

automatically hang up. Every time a DTMF tone is dialled, this period is reset.

Alternatively, parameter 9 may also be selected to end programming mode.

To program a parameter, enter the parameter number followed by the

value you wish to set. The unit will either respond with the Parameter

Confirmation Tone, or one of the Error Tones.

Note 1. if you wish to maintain the connection in programming mode (i.e. extend the 34

seconds period) then it is necessary to occasionally press a key (e.g. *, # or 7). The unit

will respond with an error tone but the connection will be kept alive.

Note 2. The # sign is not used in the values for parameters 32,33 and 34, and can be

used to immediately save the parameter.

4.2 Programming from a PC – SlimDPset program

To setup the unit from a PC you will require a special USB tool cable, available

separately, and must first install the USB driver and SlimDPset software. Refer

to the CD for more details. The unit must also be connected to the telephone

line.

Procedure:

- Connect the Doorphone to the line

- Connect the unit to the PC with the USB tool cable.

- Run the SlimDPset program. The unit will enter PC programming mode

and emit the Enter Programming tone (see chapter 3.1). If connection is

lost, it is necessary to disconnect the USB cable from unit and connect it

again. The unit will answer and, providing the SlimDPset program is

running, it will confirm its entry into programming mode again.

Refer to the SlimDPset manual for more details.

USB  PC

connection

USB  tool

Small connector