Operator`s manual

DANGER: Before proceeding, verify
the line wire is attached to the line
terminal block, the ground wire is
attached to the ground terminal block
and the neutral wire is attached to
the neutral terminal block to prevent
accidental shocks or electrocutions.
Step 2: Install and Wire the Batteries
DANGER: Make sure the
battery fuse is removed
before wiring the batteries.
1. Install the 4 batteries and wire them up as
shown in Figures 6.1 and 6.2.
Note: If using only 2 batteries, install them
in the Battery #1 and Battery #2 positions
and wire them up as shown in Figure 6.2,
except the wires to Battery #3 and #4 are
not used.
2. Use a DC voltmeter to verify the battery
string’s polarity and voltage (24VDC).
Perform troubleshooting if necessary.
Connection Finished
Battery #3
Battery #1
Battery #4
Battery #2
RED
RED
BLACK
BLACK
Figure 6.1
Battery Locations
Figure 6.2
Battery Wiring Diagram
Battery
Fuse
If using only 2
batteries, ignore
these connections.
Doc# 017-220-B0 Rev. 01 / 07 9