Operator`s manual

Mechanical Specications
Dimensions, in (mm)
H x W x D
15 x 12 x 6
(381 x 305 x 153)
Weight, lb (kg) 50 (22.7) with 4 batteries
25 (11.3) without batteries
Mounting Wall
Pole (with optional bracket)
•
•
Humidity (operating) Up to 95% (non-condensing)
Temperature Range,
°F (°C)
Operating
Storage
–40 to 122 (–40 to 50)
–40 to 167 (–40 to 75)
Altitude, ft (m)
Operating
Storage
Up to 12,000 (3658)
Up to 15,000 (4572)
AC Input and Output
Connectors
3-position terminal block
(maximum 10 AWG)
RS-232 Connector Surveillance version:
DB-9, female
Cable version:
None
•
•
Dry Contacts Surveillance version:
Two programmable dry,
single pole double-throw
relays. Contacts are rated
at 120VAC, 1A. The factory
default settings are:
C1: On battery
C2: Low battery
Cable version:
None
•
•
Display Surveillance version:
Two LEDs (1 red and 1
green) via communication
board.
Cable version:
Two LEDs (1 red and 1
green) mounted on the
enclosure visible from the
outside.
•
•
Regulatory
Electrical Safety UL 1778, CSA 22.2 #107.1,
EN50091-2, EN60950
Emission FCC subpart J, level A for
conducted and radiated EMI;
CISPR 22, EN55022 level A
for conducted and radiated
EMI.
Packaging Designed to meet
requirements for ISTA
program.
Electrical Specications
Input
Voltage (nominal, VAC) 120 or 230 (optional 220)
Frequency, Hz ±5% 60/50
Current, A 2.0 @ 120VAC
1.0 @ 220/230VAC
•
•
Output
Voltage (nominal, VAC) Surveillance version:
120 or 230 ± 10%
24, –5% to +20%
Cable version:
63 –10/+13%
•
•
•
Frequency, Hz ±5% 60/50 (auto-frequency
detection)
Current, A 4.20 @ 24VAC
1.59 @ 63VAC
0.83 @ 120VAC
0.43 @ 230VAC
•
•
•
•
Power, W/VA 100 total including auxiliary
output.
Waveform Sine wave
Load Crest Factor 3:1 (load dependent)
Output Voltage Distortion < 3% THD (resistive load)
Efciency (typical)
(backup)
>85%
>75%
Transfer Time, mS
AVR to Backup
Backup to AVR
5 (typical)
3 (typical)
Line Qualication Time,
seconds
3
Battery String Voltage,
VDC
24
Battery Charger Current,
A
3.0
Battery Charger
Temperature
Compensation
–5mV/°C/Cell default
(User selectable @ –2.5, –4,
–5 and –6mV/°C/Cell via RS-
232 connection)
Due to ongoing product improvements, specications are subject to change without notice
Doc# 017-220-B0 Rev. 01 / 07 11