Operator`s manual

A2 Using the Main Menu
The UPS’s main menu screen runs on a command line system (Figure A2.1). This
program does not recognize the backspace or delete keys even if appears that way on
the monitor. If you make a mistake and press ENTER, the UPS echoes the command
back exactly as you typed it. Press ENTER and retype the command again.
If you choose not to use the command line system, you can use the Novus User
Software to run and monitor the UPS (See Section A6).
A2.1 Main Menu Screen
The main menu screen (Figure A2.1) shows the UPS’s current input and output values,
displays if any faults or alarms are present and gives access to the submenus. It is reached
from anywhere in the menu tree (Figure A2.2) by typing 0 and pressing ENTER. The UPS is
controlled by submenu 3.
To access a particular submenu, type in the submenu number and press ENTER. To update
the main menu screen, press ENTER.
The complete menu tree is given in Figure A2.2. Tables describing the Line Status, Output
Status, Faults and Alarms displays are given in Sections A2.3, A2.4 and A2.5.
The readings on the main menu screen do not automatically update to reect changes in the
UPS’s status. Press ENTER to update the screen.
For many functions you need to enter a password. The factory set password is 1111.
•
•
Figure A2.1
Main Menu Screen
Submenu Numbers
(Figure A2.2)
Status, Faults and
Alarms Displays
(Sections A2.3 to A2.5)
Note: For cable
version, this line will
read “Secure CAB”.
Novus Micro Secure 100 Operator’s Manual
Doc# 017-220-B0 Rev. 01 / 07 14