Operator`s manual

A4.2 Setting the Date and Time
1. To learn what time and date the UPS is set to, type clock (all lower case) and press
ENTER.
The UPS responds with *clock=mm/dd/yy hh:mm:ss where the * shows the UPS
responded to your command. It uses a 24-hour clock.
2. To program the date and time type clock=mmddyy(1 space)hhmmss (no slashes, colons
or spaces between the numbers). Press ENTER.
The UPS responds with *clock=mm/dd/yy hh:mm:ss. If the date or time change is
invalid, it shows the time and date it was set to before you tried making the change.
The date and time must be entered as one complete line; you cannot change
only the time or the date alone, both must be set at the same time. If you make a
mistake, press ENTER and try again.
Finished
Novus Micro Secure 100 Operator’s Manual
Doc# 017-220-B0 Rev. 01 / 07 20