Operator`s manual
2. Connect the computer cable from any available communications port on your computer to
the RS–232 port on the UPS’s front panel (See Section A1, “Wiring the RS-232 Port”).
3. Set the communications parameters on your computer to:
• COM Port: The COM port on your computer you have selected to use.
• Baud Rate: 2400.
4. To start communications between the computer and the FXM:
Click on the screen’s on-line indicator.
OR
In the File menu, click on Connect to Novus.
If the computer cannot to connect to the UPS, a pop up screen appears asking you to
check the wiring and that you are connected to the proper com port.
Installation Finished
A6.4 Operation
The various screens are described on the following pages and operate like Web or Windows-
type screens. Point and click to change the various functions or elds.
The on line indicator shows if you are connected to the UPS. This GUI automatically polls
the UPS to obtain its status. The default setting is polling once every 3 seconds, but you can
change this in the UPS Maintenance-Unit Conguration screen in the “Status Refresh Time”
menu.
If any light is active in the Fault or Alarm elds the UPS has a malfunction. Place your mouse
over the light to learn the type of malfunction or click on it to go straight to the Alarms & Faults
screen.
To control the unit or change it’s settings
or parameters, either click on the On/Off
buttons, or choose an item from a drop
down menu. Then click on the Update
Setting button. If you do not click on this
button, the change will not be communicated
to the UPS..
Novus Micro Secure 100 Operator’s Manual
Doc# 017-220-B0 Rev. 01 / 07 24