Operator`s manual

UPS SPECIFICATION
This read-only screen shows the UPS’s factory-set
specications.
UPS MONITORING
These read-only screens show the UPS’s current input
and output values and other measurements.
Input & Output: This shows you the current line input and
UPS output values and the UPS’s present operating mode.
Battery & Inverter: This shows you the battery string’s status
as well as how many times and for how long the inverter has
been active.
Relay & Load Shed: This shows you how the front panel
dry contacts are congured. If any relays are used for load
shedding, it shows the time they are set to.
Last Event: This shows you the last event the UPS went
through. It shows what fault or alarm triggered the event.
UPS MAINTENANCE
These screens let you adjust the UPS to meet your
operating needs. To change any parameter, either
click on the On/Off buttons, or choose an item from
a drop down menu. To make the change, click on
the UPDATE SETTING button. If you do not click the
button, the change will not happen.
Unit Conguration: This lets you set the UPS’s name, input,
output and how often the GUI polls the UPS.
Battery: This lets you set the battery string voltage, charging
parameters, when the low battery warning happens, starts
the battery test and sets when the periodic battery test should
occur.
Inverter: This lets you turn the inverter on or off to start or
stop backup battery power to the load.
Relay & Load Shed : This lets you set the front panel’s dry
contact conguration.
Time & Date: This lets you set the UPS’s date and time.
Password: This lets you set the UPS’s password. The factory
set password is 1111.
Appendix
Doc# 017-220-B0 Rev. 01 / 07 25