Operator`s manual

2.2.3 Wall Mounting
Tools and Materials Required:
Secure the mounting bracket to wall studs or to a wooden backing plate that has a
minimum thickness of 1-1/4 inch and a maximum width of 4 inches that is securely
mounted to a wall stud or studs. The studs should be plumb and the mounting bracket
installed so it is levelled.
13 mm nut driver for the bolts that attach the cabinet to the mounting bracket.
Four 1/4 x 1-1/8 inch lag bolts.
Four 1/4 inch diameter at washers.
Drill with 1/8 inch bit for drilling pilot holes.
Assorted sockets and wrenches.
•
•
•
•
•
•
Procedure
1. Using the mounting bracket as a
template, drill 4 pilot holes (indicated by
the arrows in the diagram on the right)
into the wall to accept
1
/
4
inch bolts.
2. Secure the mounting bracket to the wall
with the 4 bolts and washers.
3. Secure the UPS cabinet to the mounting
bracket with the supplied bolts.
Mounting Finished
a. Hook the top of the mounting bracket
under the case’s attachment tting.
b. Secure the cabinet to the mounting bracket.
Front Side Wall or
studs
15
Installation
Doc# 017-221-B0 Rev 0307