Operator`s manual

4.1 Wiring the RS-232 Port
The UPS’s front panel has a DE-9 female connector. When connected to a PC with Window’s
HyperTerminal or other terminal emulation software, the UPS can be remotely monitored and
controlled with it’s command-line system (See Sections 4.2 to 4.4). The Novus Micro Graphical
User Interface (GUI) provides a Windows or Web type of control (See Section 4.6).
Procedure
1. Connect a 9-pin, fully shielded, straight-
through DE-9 to DE-9 connector cable
between the computer’s port and the
UPS’s port.
2. Congure the communications
parameters to the values shown in the
terminal set up table.
RS-232 Wiring Finished
Terminal Set Up Table
Emulation
Type
VT 100 or
Compatible
Backspace N/A
Duplex Mode Half Duplex Break Length N/A
Xon/Xoff
Flow Control
None Emulation
Type
N/A
RTS/CTS
Flow Control
Off
Communication
Parameters
Line Wrap On Handshaking Software
Handshaking
Screen Scroll On Baud Rate 2400 bps
CR
Translation
CR Data Format 8 Data, No Parity,
1 Stop Bit
Doc# 017-221-B0 Rev 03/07 33
Communication