Operator`s manual
4. To start communications between the computer and the Micro:
Click on the screen’s online indicator.
OR
In the File menu, click on Connect to Micro.
Installation Finished
4.6.4 Operation
The various screens in Micro monitoring software are described on the following pages.
These screens (Figure 4.6.1) act like a Web or Windows-type screens. Point and click to
change the various functions or elds.
The on line indicator shows if you are connected to the UPS. To turn communications on or off,
click on it or, on the screen’s File menu, click on Connect to [or Disconnect from] Micro.
If the Fault or Alarm Indicator is on, the UPS has a malfunction (See Section 3.6,
“Troubleshooting”).
UPS SPECIFICATIONS
This read-only screen shows the UPS’s
factory specications.
UPS MONITORING
These read-only screens show the UPS’s
present input and output values and other
settings.
Input & Output: This shows you the present line
input and UPS output values, power factor and the
UPS’s present operating mode.
Battery & Inverter: This shows you the battery
string’s status as well as how many times and for
how long the inverter has been active.
Relay & Load Shed: This shows you how the
front panel dry contacts are congured (Also See
Section 1.3, “Dry Contacts”). If any relays are used
for load shedding, it shows the time they are set to.
Last Event: This shows you the last event the
UPS went through (Also See Section 3.7, “Last
Event Log”). It shows what fault or alarm triggered
the event.
Novus Micro Operator’s Manual
Doc# 017-221-B0 Rev 03 /07 44