Operator`s manual
UPS MAINTENANCE
These screens let you adjust the UPS to meet your
operating needs (Also See Sections 3.4, “Operating the
UPS” and 4.3, “Operating the UPS”).
Unit Conguration: This lets you set the UPS’s name,
input, output and other parameters.
Battery: This lets you set the battery string voltage,
charging parameters, when the low battery warning
happens, starts the battery test and sets when the periodic
battery test occurs (if used).
Inverter: This lets you turn the inverter on or off to provide
backup battery power to the load.
Relay & Load Shed : This lets you set the front panel’s dry
contact conguration.
Time & Date: This lets you set the UPS’s date and time.
Password: This lets you set the UPS’s password. The
factory set password is 1111.
ALARMS & FAULTS
This read-only screen shows you what malfunctions
the UPS has. When the fault or alarm indicators in the
top right corner of the screen are lit go to this screen to
learn what it is (See Section 3.6, “Troubleshooting” for
descriptions of these items).
EVENT HISTORY
This screen shows you the last 100 events the UPS went
through. Choosing a number in the Event Index list box
and then clicking on the Show Event button will show
you the event, when it happened and what fault or alarm
caused it (Also See Sections 3.7, “Last Event Log” or 4.4,
“Accessing the 100-Event Log”).
Clicking on the Clear History button clears the log. This
action cannot be undone.
COMMUNICATIONS
This screen changes the UPS’s communication
parameters to suit your needs.
Doc# 017-221-B0 Rev 03/07 45
Communication