Owner's manual

ManualsBrandsAlpha Technologies ManualsEquipmentPHSD

Power

The PWE High Security Device (PHSD) mounts to PWE-3, 6, 9, or D36 enclosures to provide security from theft and

vandalism for batteries and power supplies. The PHSD is high grade stainless steel, which not only provides physical

security, but corrosion resistance and a strong visual deterrence as well.

Tools Required:

• 3/8" drive hand drill

• 9/32" (#K) drill bit

• 7/16" nut driver or socket

Material List, PWE High Security Device

Alpha P/N Description Qty

605-404-G1-002 Side Bracket 1

605-405-G1-002 Side Bracket with Lock 1

605-406-G1-001 Security Bar 1

630-109-12 Bolts, 1/4" 20x3/4" 8

633-013-12 Flat Washers 8

634-059-12 KEPS Hex Nuts, 1/4-20 8

PWE High Security Device

Field Installation Instructions

1 1/4"

1 5/8"

1 3/8"

7 1/2"

Right side view

Left side view

Dimensions and Speciﬁ cations

In addition:

A security lock (Master Lock

No. 3 or equivalent) is required

to secure the enclosure. The

user-supplied lock must meet the

following dimensions.

Where:

A= 1/4" (6.35mm)

B= 5/8" (15.84mm)

C= 1/2" (12.7mm)

WARNING!

Use EXTREME CAUTION when drilling into the enclosure. Clear equipment and wiring from the

area into which you are drilling.

PWE High Security Device Kit

Fig. 1, PWE-3 Enclosure

(31.49mm)

(41.27mm)

(31.49mm)

(34.92mm)

(190.5mm)

(50.8mm)

Summary of content (2 pages)

PAGE 1
Power PWE High Security Device Field Installation Instructions ® The PWE High Security Device (PHSD) mounts to PWE-3, 6, 9, or D36 enclosures to provide security from theft and vandalism for batteries and power supplies. The PHSD is high grade stainless steel, which not only provides physical security, but corrosion resistance and a strong visual deterrence as well. WARNING! Use EXTREME CAUTION when drilling into the enclosure. Clear equipment and wiring from the area into which you are drilling.
PAGE 2
™™ Total Power Solutions Argus Argus Cordex Cordex CXRC CXRC2RU 4RUSeries Series Installing the Security Bar 1. Referring to Fig. 1 for accurate measurements, position the right side bracket on the right side of the enclosure. See Figs. 2 and 3. 2. Mark and drill the four mounting holes. 3. Use the bolts and nuts provided to secure the bracket to the enclosure. 4. Repeat steps 1, 2, and 3 for the left side bracket. See Figs. 2 and 4. 5.