Manual

031-161-B0-006, Rev. F50
2.0 Installation, continued
2.9 Status Monitoring Transponder Bracket Installation Instructions
Tools and Materials Required:
• #10-32 nuts and fl at washers
• 3/8" (9.5mm) socket wrench or nut driver
Installation Procedure:
1. Position status monitoring bracket over status monitor, and align bracket slots with PEM
studs (located on enclosure).
2. After bracket and status monitor are in position, apply fl at washers and #10-32 nuts to
PEM studs. Tighten using 3/8” (9.5mm) socket wrench or nut driver.
Status Monitoring
Bracket
Bracket
Slots
Status Monitoring
Transponder
Fig. 2-36, Status Monitoring Bracket Location in PWE Series Enclosure