Operator`s manual

Figure 3.

System Bypass Schematic

120V IN - 120V/240V OUT

3.2 Bypass Switch Operating Procedure

NOTES:

1. The UPS will be internally configured for either 208V or 240V.

Check the nameplate rating of the UPS to verify the correct voltage.

2. Omit this connection if 120V output is not required or available.

3. OPERATION

5. SCHEMATIC DIAGRAMS

• Always operate the switch with a quick continuous motion, do not hold it in mid-

position.

• DO NOT operate the bypass switch while the UPS is in inverter mode (LINE FAIL-

URE light on the front panel will be ON).

Bypass Switch - Closed

Bypass Switch - Open