Data Sheet

Product Specification Sheet APS531 - Rev. 08/2015
RTM Series Button Modules (For modular door stations)
42 Central Drive • Farmingdale • NY • 11735-1202 • Phone: [phone] • Fax: [phone]
TOLL-FREE: [phone] • Web: AlphaCommunications.com • Email: [e-mail]
Copyright© 1998-2015 Alpha Communications® - All Rights Reserved.
Due to continuous product improvement, all colors, sizes, materials, finishes and specifications are subject to change without notice.
RTM4 4-Button Module
RTM1 1-Button Module RTM2 2-Button Module
RTM3 3-Button Module
RTM Series Push Buttons for Modular Series Door
Stations
The RTM push button modules are designed to be used with the
Alpha Communications® / S.T.R.™ modular series door entry
stations. There are four (4) configurations available from one (1)
to four (4) push buttons per module.
All RTM push buttons feature LED illumination and plug-in
connector for easy wiring and maintenance.
All RTM push button modules are 3.94"w x 3.94"h (100mm x
100mm), and are made to snap into the MT series modular panel
trim frame(s).
To service the RTM series modules, once installed, use the model
13510 key / tool unit.
ARCHITECTS' AND ENGINEERS' SPECIFICATIONS
Push button module(s) shall be Alpha Communications® / S.T.R.™
RTM series or approved equal. Push button(s) shall be modular
type and shall be used in conjunction with the proper MT series
modular panel frame(s). Contractor shall provide the proper
number of 1,2,3 or 4 button modules as needed.
All RTM button modules shall feature LED illumination and plug-in
connector for easy wiring and system maintenance.
Contractor shall observe all local and national electrical and
building codes.
CONFIGURATIONS AVAILABLE
Model# # of buttons
RTM1* 1
RTM2* 2
RTM3* 3
RTM4* 4
*Please add the following suffix to the model# shown above. Add
'A' for use with HT3009 and/or HT2009 (2-wire systems). Add 'B'
for use with HT3011 and/or HT2011 (2-wire loop ReliaBUS™
systems) or for use with HT3033 / HT40 / HT45 (2-wire loop
QwikBUS™ systems).