Data Sheet

Product Specification Sheet APS254 - Rev. 07/2013
SS911 Tamper-resistant Remote Station (RM5000EX / CB901EX Series)
42 Central Drive • Farmingdale • NY • 11735-1202 • Phone: [phone] • Fax: [phone]
TOLL-FREE: [phone] • Web: AlphaCommunications.com • Email: [e-mail]
Copyright© 1998-2014 Alpha Communications® - All Rights Reserved.
Due to continuous product improvement, all colors, sizes, materials, finishes and specifications are subject to change without notice.
< Previous (APS253) Next (APS255) >
Architects' And Engineers'
Specifications
The remote station(s) shall be Alpha
Communications® / Ring model SS911 or
approved equivalent. Remote(s) shall have clear
two-way communications. Remote(s)
shall feature a tamper-resistant design to
protect the speaker, microphone, LED, call
button, and circuitry from external abuse and
the elements. Remote faceplate shall be made of
high quality 11 gauge Stainless Steel, in a
brushed finish.
Remote(s) flush mounts in a 3.50" deep three
gang electrical box (our model BBF910) with four
tamper resistant screws (not included), or can
be surface mounted using a model BBS910
surface back box. Remote is designed to work
with the RM5000EX and/or CB901EX
microprocessor intercom systems. When used as
a elevator remote station, calling to the AND16
series annunciator, each SS911 requires the
contractor to furnish and install a model AN912
annunciator control module.
Contractor shall observe all local and national
electrical and building codes.
SS911 Tamper-Resistant Remote Substation
The SS911 is a tamper-resistant remote station designed to protect the speaker,
microphone, LED, call button, and circuitry from external abuse and the elements.
This remote station is ideally suited for use in elevator, correctional facilities,
institutions, parking facilities and secured entrances. The SS911 is designed to work
with the RM5000EX and/or CB901EX microprocessor intercom systems.
The face plate is constructed of high quality 11 gauge Stainless Steel with a brushed
finish. The weather-resistant 45 ohm speaker is physically protected by an offset
baffle and the microphone is encased in a machined block to prevent tampering. For
a wider viewing angle and considerable security, the LED is mounted behind .250"
thick LUCITE. Heavy duty piezo call switches offer strength and reliability with no
moving parts to wear out.
Remote(s) flush mounts in a 3.5" deep three gang electrical box (our model BBF910)
with four tamper resistant screws (not included), or can be surface mounted using a
model BBS910 surface back box.
When used as a elevator remote station, calling to the AND16 series annunciator,
each SS911 requires a model AN912 annunciator control module.
Features
Clear two-way communications
Tamper-Resistant Stainless Steel
Call button and L.E.D. Indicator
Easy installation
Simple home-run wiring
Specifications
Dimensions: 6.375" (162mm) W x 4.475" (114mm) H x 3.00" (77mm) D
Weight: 1.5 lbs
Finish: Brushed finish
Material: 11 gauge Stainless Steel
Mounting:
Surface Housing: BBS910
Flush Mounting: BBF910 3.50" deep three gang electrical box
with four tamper resistant screws (not included)