Data Sheet

Product Specification Sheet APS975 - Rev. 01/2016
UMF1000 QwikBUS™ Intercom Flush HousingUMF1000 QwikBUS™ Intercom Flush Housing
42 Central Drive • Farmingdale • NY • 11735-1202 • Phone: [phone] • Fax: [phone] Central Drive • Farmingdale • NY • 11735-1202 • Phone: [phone] • Fax: [phone]
TOLL-FREE: [phone] • Web: AlphaCommunications.com • Email: [e-mail]-FREE: [phone] • Web: AlphaCommunications.com • Email: [e-mail]
Copyright© 1998-2016 Alpha Communications® - All Rights Reserved.
Due to continuous product improvement, all colors, sizes, materials, finishes and specifications are subject to change without notice.
UMF1000 Flush HousingUMF1000 Flush Housing
HWB Installation Screws and Mounting BracketsHWB Installation Screws and Mounting Brackets
UMF1000 QwikBUS™ Intercom Flush HousingUMF1000 QwikBUS™ Intercom Flush Housing
The Alpha Communications® / S.T.R.™ UMF1000 Flush Intercom
Housings are designed to be used with the FS1000 series, FSE1000
series, FS1500 series, FSE1500 series, and FSV1000
series QwikBUS™ intercom stations, to allow the stations to
be mounted flush into the finished wall.
These plastic housings are used in conjunction with the model HWB
mounting screws and brackets, typically for a sheet-rock or
gypsum type wall. Depending on the mounting location, these flush
housings may also be fastened directly to a wooden or metallic
wall stud.
FeaturesFeatures
Made from high-impact ABS plastic
Can work with a variety of QwikBUS™ Intercom Stations
SpecificationsSpecifications
Dimensions:
The UMF1000 flush housings are
3.25"W (83mm) x 5.375"H (137mm) x
1.80"D (46mm).
Architects' And Engineers' SpecificationsArchitects' And Engineers' Specifications
The Flush Intercom Housings shall be Alpha Communications® /
S.T.R.™ model UMF1000 or exact equal. The Flush Intercom
Housings are designed to be used with the FS1000 series, FSE1000
series, FS1500 series, FSE1500 series, and FSV1000
series QwikBUS™ intercom stations, to allow the stations to
be mounted flush into the finished wall. The UMF1000 shall be
made from high-impact ABS plastic.
Contractor shall also furnish and install the model HWB mounting
screws and brackets, typically for a sheet-rock or gypsum type
wall. Depending on the mounting location, these flush housings
may also be fastened directly to a wooden or metallic wall stud, as
directed by the Architect.
Contractor shall observe all local and national electrical
and building codes.