User Manual

MONITOR DESCRIPTION
1 2 3
ON DIP
4 5 6
l
h
j
i
k
Installation terminals and dip switch:
( ):WHITE HZ+
( ):GREEN HZ-
a. .Microphone
b. 4.3” TFT colour screen.
c. .Close push button
d. Menu push buttons.
e. “Do not disturb” push button/indicator.
f. .Start/stop communication function push button
During standby: Display door panel image.
g. releaseDoor .function push button
During standby: Press for 10 seconds to
activate/deactivate the “doctor mode” function
(function code [9018] must be activated).
h. Attachment holes.
i. .Horizontal cable input
j. Connector.
k. BUS connection terminals.
l. .Con#guration DIP switch
Connection terminals:
L1, L2: BUS connection (non-polarised).
HZ+, HZ-: .Door bell push button connection
CALL REPEATER, GND: Call repeater connection (SAR-12/24).
(12Vcc/50mAmaximum).
Configuration dip switch:
Dip6: Sets the end of line. Set to ON in monitors where the bus cable
terminates. Set to OFF only in intermediate monitors.
Dip1 to Dip5: Set the monitor address (addresses 0 to 31).
Switches set to OFF have a value of zero.
The values of the switches set to ON are shown in the enclosed chart.
The monitor code will be the sum of the values of the switches set to
ON.
1 2 3
ON DIP
4 5 6
1 2 3
ON
DIP
4 5 6
L1
L2
(R ):ED CALL REPEATER
( ):BLACK GND
( ):YELLOW
DO NOT USE
Menu access and function selection push button.
Menu back push button.
Power supply .status LED
Push button: .End call/communication
During standby: Enter/exit menu mode.
“Do not disturb” function access push button.
LED on: “do not disturb” mode activated.
LED blinking: “doctor mode” activated.
LED off: function not activated.
Menu push buttons and status LEDs:
4
1 2 3
ON DIP
4 5 6
E : 0 + 0 + 4 + 0 +16 = 20xample
Switch number: 1 2 3 4 5
valueON : 1 2 4 8 16
Value chart
Menu scroll down push button.
Menu scroll up push button.
VESTA2 G 2 MONITORB
b
c
f
d
g
a
e