Manual

 Tenant Personal Code
To set a tenant personal code, Click the Directory button in the upper left corner of the main Editor Screen. Select
the tenant from the list on the left, and click the “Door Monitor” tab.
Enter a code of 1-8 characters consisting of numbers 1 and 2 (video units can also use 3 and 4). An example might
be “12122” or “222”. Once the code is entered the code is hidden behind 8 asterisks for security reasons. If a
tenant forgets their number, you must reenter a new code here. There is no way to see the code after entry.
 Tenant Operation
To activate the door monitoring from the apartment station, hold down the button for three seconds until the
red light behind the switch flashes to indicate the system is active. The system is now set. If the tenant is
leaving the apartment, the door must be open and shut within the predetermined delay time.
To deactivate the door monitoring from the apartment station, enter the personal combination code using the
and buttons (also the and buttons with the VFSE1500 video stations) within the predetermined delay
time. If a mistake is made, start your code sequence again and the system will disregard your previous entries.
 Concierge enabling an apartment’s monitoring
If a tenant comes down and has forgotten to activate their door monitor, the concierge can activate it from his
console. To enable this ability select the Options tab for the concierge station and check the box for “Apartment
Door Monitoring can be enabled from this Entry”
Select the tenant from the main directory screen, when the call box appears there will be a key icon in the upper
right side. A gray key indicates the system is not active and a gold key indicates it is active. Clicking on the key icon
will turn it gold, indicating that the monitor is now active. The concierge cannot disarm the monitor remotely but
he does have the ability to temporarily shunt it for a length of time.