User manual

Chapter 5 Parameter Introductions
116
Running Freq.(Hz)
Time
Acc Time
Dec Time
③
②
①
①
③
②
Fig. 5-1-5 S-curve acceleration/deceleration
P1.06 Time of S-curve initial
Range: 10.0 ～ 50.0% 【 20.0% 】
P1.07 Time of S-curve rising
Range: 10.0 80.0% 60.0% ～ 【 】
Note:
P1.06 an
P1.06+P
d P1.07 are only active when the Acc/Dec mode is S-curve mode (P1.05=1) and
1.07≤90%.
reases from 0;
zero.
the conveying load such as elevator and
c .
Starting process of S-curve is shown in Fig. 5-1-5 as “①”, where the changing rate of
output frequency inc
Rising process of S-curve is shown in Fig. 5-1-5 as “②”, where the changing rate of
output frequency is constant;
Ending process of S-curve is shown in Fig. 5-1-5 as “③”, where the changing rate of
output frequency decreases to
 Tips:
Scurve Acc/Dec mode is suitable for
onveying belt
P1. 8 Stop mod0 e
Range: 0～2【0】
0: Deceleration to stop o stop 1: Coast t
2: Deceleration +DC braking
ng the stop command, the inverter reduces its output frequency within the
tops when the frequency decreases to 0.
◆
Note:
◆0: Dec-to-stop
After receivi
Dec time, and s
1: Coast-to-stop