User manual

Chapter 5 Parameter Introductions
Setting Function Setting Function
SS1 Multi-step Speed 27 SS2 Multi-step Speed 26
SS3 Multi-step Speed 29
Command channel switch to
Keyboard control
28
T1 Acc/Dec time 1 31 T2 Acc/Dec time 2 30
T3 Acc/Dec time 3 33 T4 Acc/Dec time 4 32
TT1 Acc/Dec time 35 TT2 Acc/Dec time 34
Forced outage normally close 37
EH0: External fault signal
normally open
36
EH1: External fault signal
normally close
39
EI0: External interrupt signal
normally open
38
EI1: External interrupt signal
normally close
41 Reserved 40
Start PLC operation 43 Pause the PLC operating 42
Reset PLC stop status 45
Start wobble frequency
operation
44
Reset the wobble frequency
operating status
47 Start PID operation 46
Reserved 49 Timing drive input 48
Counter trig signal input 51 Counter clear 50
Actual Length clear 53 Reserved 52
PUL: Pulse input (If have 2
signals input, follow X7 )
55
Single-phase speed measuring
input (If have 2 signals input,
follow X7 )
54
Speed measuring input SM1
(only for X7)
57
Speed measuring input SM2
(only for X8)
56
Notes to functions listed in Table 5-3-1:
0: NULL: No defined
The defined terminal is invalid. The inverter does not detect the status of the terminal nor
response to the terminal. In other words, the function of terminal is forbidden .To avoid
disturbance or mistake action effectively, define the terminals that are not in use as this
function
1～5:Operating modes
◆Refer to P3.09 operating modes setup.
6:RST: Reset
◆In fault state, the inverter can be reset by keyboard by pressing “STOP/RESET ” or by
terminal on or off, if the terminal has been set as RST function. In running state, it can
stop the inverter according to selection of stop mode. RST function is active at the
126