Operating instructions

ManualsBrandsAlpha ManualsConsumer electronicsXM 6015 Series

XM Series Side Panel with USM

S402 S401

APM/ USM Logic Upgrade

NOTE: THE UNIT CAN CONTINUE

TO OPERATE AS A NON-

STANDBY POWER SUPPLY WITH

THE MAIN CIRCUIT MODULE

REMOVED.

Main Circuit Module Assembly (top view)

Serial Connector

Tamper

Switch

Connector

Parallel Connec-

tor

(Cables to the

right)

Main Circuit

Module

Access Handle

USM Connec-

tor Access

6.11 USM (Universal Status Monitor)

The optional, USM status monitoring upgrade plugs directly into the APM logic card.

Note: The Main Circuit Module assembly must be completely removed from the power

module when installing the USM (see section 6.8). Status monitoring interfaces are listed

according to their manufacturer, along with the associated parts. The USM can also

accommodate a tamper switch assembly to indicate unauthorized enclosure entries.

1. Remove the APM logic card from the Main Circuit Module assembly (if installed).

Verify that the APM's Auto-Equalize and Self-test switches are in their desired

positions (see section 6.10). Plug the USM logic card into connector J2 located on

the component side of the APM card. Set the USM switches according to the status

monitoring system you will be using (see opposite page). Plug the card into the Main

Circuit Module assembly.

2. If a main board IC upgrade is included, carefully remove the IC (U8) from the main

board assembly. Replace it with the one included with the USM upgrade kit. Posi-

tion the IC with the notch to the left (pin 1 notch in the lower-left corner). Caution:

The IC is static sensitive and can be easily damaged if not handled properly.

3. Reinstall the Main Circuit Module assembly. Note: Make sure the assembly slides

straight in and seats firmly into the card edge connector. Plug the communications

cable into the USM connector. Note: The cable fits in one direction only with the

incoming cables to the right (see below). Test the unit for normal operation.

6. INSTALLATION

Main Circuit Module Assembly

SDD Display

Battery

APM / USM Board

(Located on back)

IC (U8)

- Pin 1 in lower left corner -