User Manual

Speed Control - Press "C." [Go/Speed Up] button to move forward. Your Club Booster has 6

speeds and defaults to Speed 1 each time you stop, for safety. Cycle through speeds by pressing

Go/Speed Up and Reverse/Slow Down; each time you press Up or Down, the speed changes.

Reverse/Slow Down - Press and hold the "4 多 " [Reverse/Slow Down] button at stationary to

reverse. Release the button and the unit will gradually stop. Left/Right turn - Press and hold the

"t" [Left] or "f" [Right] buttons to turn left

or right. Slow to Speed 1 or Speed 2 to turn a fixed-front wheel cart.

Stop - Press the "0" [Stop] button to bring your Club Booster to a gradual stop.

15-Yard/30-Ya『d Presets - Press "0" or "G" button and your cart will travel

those preset yardages. You are able to steer your cart while in Preset Mode. Free-Wheel Mode -

You can free-wheel to push your cart by holding down the Stop button for 3 seconds. The red

light on the Club Booster console will flash. Press any button to exit Free-Wheel Mode.

Gyro On/Off - Press "0" [Gyro] button to deactivate the gyro. The yellow light on the Club Booster

console will turn off. Turn off the gyro when you are using your Club Booster for power-assist,

when walking with the unit and steering manually. Keypad Lock - Press the "(!)" [Keypad Lock]

button to lock the keypad so buttons are not accidently activated. The red light on the remote

will flash. Press the Keypad Lock button and any other button within 3 seconds to exit Lock Mode.

Charging The Remote - Charge the remote by plugging the micro USB cable (included) into the

remote and any USB charging inlet.

Pairing The Remote - The remote is paired to your Club Booster at the factory. If your unit loses

pairing to the remote, use the following procedure: 1) Turn off the Club Booster, 2) Press and

hold both the "Stop" and "30-Yard" buttons until the light in the upper corner flashes, 3) Turn on

the Club Booster, 4) Release the "Stop" and "30" buttons. The remote is paired when the red light

stops flashing.

Model：

Club Booster V2 remote

PAGE 1
Model：Club Booster V2 remote Speed Control - Press "C." [Go/Speed Up] button to move forward. Your Club Booster has 6 speeds and defaults to Speed 1 each time you stop, for safety. Cycle through speeds by pressing Go/Speed Up and Reverse/Slow Down; each time you press Up or Down, the speed changes. Reverse/Slow Down - Press and hold the "4 多 " [Reverse/Slow Down] button at stationary to reverse. Release the button and the unit will gradually stop.
PAGE 2
- English: " This device complies with Industry Canada licence-exempt RSS standard( s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device." - French:" Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence.
PAGE 3
FCC STATEMENT : This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.