Installation guide

IPDP - installation and operating instructions
34
3.2.3 Time Parameters
After making changes use the save changes button.
1. max. time, for which the DoorPhone is hanging up, this time can be
extended during call by sign choice from telephone (* or #) – see page 31.
2. Number of incoming call rings, the DoorPhone pick up after preseted
number of rings. After detection first ring – LED on front panel blinking. The
number can be set from 1 to 9.
3. max. time [sec] among button presses [range 1-9]
switch closing – if time between two next presses is bigger than w time,
the code is not evaluated correctly.
dialing – if the button, we are pressing, is the first password number for
switch closing, so the choice is delayed by this w time.
4. time [sec] for which the guard will hang up, before repeated dialing (button
pressing during call or dialing, busy tone detection) [range 1-5]
5. after finishing the dialing it calculates time (ringing tones). If the number
exceeds time in second, it will hang up [range 10-99]. The dialing is
repeated in case, when the dialing mode of 2 groups is set.
6. In default is status of DoorPhone signalling acoustically. If signalling makes
problem, so this signalling pick up / hang up prohibited.
7. In default is status of DoorPhone signalling acoustically. If signalling makes
problem, so this signalling others tones prohibited.
8. Default value – presetings to the firm settings. After making changes use
the save changes button.