Installation guide

4.7 System Setting
Parameter Value Meaning Basic
6# s
number of non-fitted buttons of basic module
The basic module is fitted with 2 buttons as standard, i.e. s = 0, s = 1 is set up
for basic module with one button and s = 2 for module without buttons. This
setting is a factory one, no service can change it and so it is recommended not
to change this parameter.
Note: Connecting. to the line the value of this parameter is checked and if not
satisfactory form unknown reasons, so it is set up to s = 0 (fitted with 2 buttons).
Atention !!! This parameter does not basically affect the correct function
of guard.
Parametr Value Description Basic
6 z
Switching off acoustic signalization
3
In default is status of Door phone signalling acoustically. It can cause a problem of
incorrect detection of tones by PBX. By parametr „z“ you can switch off this
acoustic signalization. The values are
z=0 – all signalling is switched off
z=1 – pick up and hang up tones are active only
z=2 – other tones active only
(except pick up and hang up)
z=3 – all tones are active – default
Parametr Value Description Basic
6*
t
Delay of line connection ( Siemens PBX)
1
The delay of line picks up ( OFF HOOK) for new PBX types (particularly
Siemens) is:
t=1 – standard operation
t=0 – delayed start